Hey guys,
Would love some ideas what else I could try?
I can't get my ESP32_Devkitc_v4 to work unfortunately. I connected all the wires according
to the diagram, changed the screen to 4SPI with a solder bridge, flashed as WEMOS LOLIN 32 - black screen
Code: Select all
Compressed 203568 bytes to 104620...
Writing at 0x00010000... (14 %)
Writing at 0x00014000... (28 %)
Writing at 0x00018000... (42 %)
Writing at 0x0001c000... (57 %)
Writing at 0x00020000... (71 %)
Writing at 0x00024000... (85 %)
Writing at 0x00028000... (100 %)
Wrote 203568 bytes (104620 compressed) at 0x00010000 in 2.2 seconds (effective 723.8 kbit/s)...
Hash of data verified.
Compressed 3072 bytes to 128...
Writing at 0x00008000... (100 %)
Wrote 3072 bytes (128 compressed) at 0x00008000 in 0.0 seconds (effective 2234.2 kbit/s)...
Hash of data verified.
Leaving...
Hard resetting via RTS pin...
Everything seems good on the Arduino side, no problems.
What I tried:
- Solder different gauge wires
- Flash as ESP32 Dev Module
- Reinstall Arduino
So far I have not been able to confirm that the screen works at all
IMG-20210720-214140.jpg
IMG-20210720-214214.jpg
IMG-20210720-214921.jpg
Excuse my shabby solder job, I know it looks quite bad
I didn't have any DuPont wires handy but made sure that all connections connect as they should with a multimeter. All Ground pins make connection as well.
Thanks for any help!
You do not have the required permissions to view the files attached to this post.