Mapping buttons doesn’t work on Strider

User avatar
gvfo
Posts: 6
Joined: Wed Oct 06, 2021 9:52 pm
Been thanked: 1 time

Mapping buttons doesn’t work on Strider

Unread post by gvfo »

Hello there!

New forum user and MiSTer owner here.

So, I just installed the new Strider core from Jotego, the one with the correct star field. So far so good. After mapping buttons to this core (I’m using an M30), the core simply ignores my mapping and uses the default buttons.

As soon as I enter the core and press anything, the interface shows my mapped buttons correctly.

Anything I’m missing here? I’ve mapped buttons in lots of arcade cores and, so far, this was the first that didn’t work.

Thanks immensely!
dazzer69
Posts: 39
Joined: Fri Jul 03, 2020 8:34 pm
Has thanked: 18 times
Been thanked: 11 times

Re: Mapping buttons doesn’t work on Strider

Unread post by dazzer69 »

I had similar problem. Deleting all strider CFG files and starting over seemed to solve it
User avatar
gvfo
Posts: 6
Joined: Wed Oct 06, 2021 9:52 pm
Been thanked: 1 time

Re: Mapping buttons doesn’t work on Strider

Unread post by gvfo »

dazzer69 wrote: Thu Oct 07, 2021 6:22 am I had similar problem. Deleting all strider CFG files and starting over seemed to solve it
Thanks for your answer!

I deleted both .CFG in the /media/fat/config and and the .MAP, but it didn’t solve the problem, unfortunately.
dazzer69
Posts: 39
Joined: Fri Jul 03, 2020 8:34 pm
Has thanked: 18 times
Been thanked: 11 times

Re: Mapping buttons doesn’t work on Strider

Unread post by dazzer69 »

There is also a new .mra up for it now on JTBIN.
User avatar
gvfo
Posts: 6
Joined: Wed Oct 06, 2021 9:52 pm
Been thanked: 1 time

Re: Mapping buttons doesn’t work on Strider

Unread post by gvfo »

dazzer69 wrote: Fri Oct 08, 2021 12:04 pm There is also a new .mra up for it now on JTBIN.
Updating to the new version did the trick. Just to be sure I deleted the .map again before running the script. Thanks a lot, dazzer69!
Post Reply