MiSTer FPGA Forum

Hi guys, first post on the new forum, soldered my 5.6 i/o board, vga output is ok, when I use a vga to scart output tho I have a nasty out of sync rolling picture, followed the wiki diagram for making the cables and I don't believe I messed anything up? CRT works fine with a NEO Geo and a SNES used for testing.

forced_scandoubler=0
ypbpr=0
composite_sync=1
vga_scaler=0

Have tested other settings to no avail, SOG is off, tried menu in pal and ntsc.

I am using no resistances on the cable, I have an OSSC I can try if it can help troubleshoot the issue, please help I am at a loss after 3 evenings spent (wasted) troubleshooting this issue:

https://www.youtube.com/watch?v=bTGLUWSRO1I

Thanks in advance for your help, I have been reading wikis, forum and reddit pages and I am out of resources at this point.

What kind of cable are you using for VGA to SCART? Have you already tried swapping the VGA Jumper between 3.3v, 5v, or off?

Basically I somehow had the wiring wrong, now everything seems to be ok, colors are a bit over saturated tho.