MiSTer FPGA Forum

Posted: **Tue Mar 07, 2023 10:33 pm**

Hi,
I am back to using Mister after some time, I've used Update-All script on my setup, script updated by itself, but I am unable to use it since I have old system, is there any option to update system without reflashing my 512gb MicroSD?

Thx

EDIT - After updating no video from HDMI...

Posted: **Wed Mar 08, 2023 12:25 pm**

If the installation is that old it is probably best to do a fresh installation. There is a tool to migrate to a new card now too.

Posted: **Wed Mar 08, 2023 3:17 pm**

AngelicLiver wrote: ↑Wed Mar 08, 2023 12:25 pm
If the installation is that old it is probably best to do a fresh installation. There is a tool to migrate to a new card now too.

I am backing up my card now, but it is bit long process, where is this migration tool?

Posted: **Wed Mar 08, 2023 3:53 pm**

On the page I linked, under the scripts section; migrate_sd.sh. If you do not have video output try using SSH.

MiSTer FPGA Forum

Updating System After Not Using MiSTer for Some Time

Updating System After Not Using MiSTer for Some Time

Re: Updating System After Not Using MiSTer for Some Time

Re: Updating System After Not Using MiSTer for Some Time

Re: Updating System After Not Using MiSTer for Some Time