The online community for MiSTer FPGA enthusiasts
https://misterfpga.org/
Hi,
I am in the middle of making a case to fit my mister multisystem and i wanted to hide a tapto inside the case. On the Tapto website is see there is a PN532 module that can be used. Is there a tutorial on how to set the module up? It seams alot cheaper and smaller than a normal reader.
All of the documentation for TapTo can be found in the GitHub repo. If you want to take the DIY approach and use the PN532 module, you need to understand that in order for it to work, it needs to be coupled with a compatible USB to TTL converter.
There is a full DIY guide here with a custom PCB you will need to order from JLCPCB/PCBWAY etc. Alternatively you can just purchase an off-the-shelf ACR122U.
That is exactly what i wanted. Thankyou very much.
Looking at the cost and the amount of time involved I might just buy an ACR122U. I dont need 5 PCB,s and the ACR122U could be made to fit inside my case. I might try the build though just to understand it more.
Thanks for the reply.
It’s really simple, went the DIY for my build. Buy a PN532 module with header and cables, also buy a CP2102 USB to TTL module. Connect them together (I had to switch the pins RX and TX when wiring) and it will be detected by TapTo
Also I tired a PL2303 chip based USB and it would not work - apparently an issue with Linux support.
Excellent
Do you have links where to buy plz? When you say simple I am leaning towards this build. Also do you have a picture of it built so i can guage the size to see if it will fit in my case?
Thanks in advance.
Vendors can be found in the GitHub repo. Images of hardware and case designs also (download an STL to preview the footprint).
AngelicLiver wrote: ↑Wed Mar 13, 2024 10:45 amVendors can be found in the GitHub repo. Images of hardware and case designs also (download an STL to preview the footprint).
I have been going over the github for a while now. I am now looking at PN532 NFC USB Module - Type C. It is cheap and fits the footprint i desire. Compatibility may be a problem. Using a simple usb ttl is the other option. I dont really want to have to get PCBs printed because i only need 1. I will keep reading and learning. Thanks.
I purchased the parts on Amazon. The PN532 often is listed with the cables and then you need the usb TTL with CP2102 chip, just do a search you will find many available for cheap.